Steren RM-8 - Erase Programmed Codes; Find Current Code

ENGLISH
ENGLISH-06
7.- Press Power once again to check that your device turns on. Test the
remote control functions, it must to control almost the total of functions,
otherwise repeat the instructions.
Be patient. If your device don’t turn off after few tries pressing
Power, repeat from step 2.
Do not press different buttons as we mentioned in this instruction
manual.
Do not exceed more than 30 seconds between each step.
Otherwise the remote control exit from the Search mode and you
must to repeat from step 2
HOW TO ERASE PROGRAMMED CODES
If you want to erase a specic code, you can use the quick program
method or the automatic search method; when you enter the new code,
automatically will erase the old code.
HOW TO FIND OUT WHICH CODE IS CURRENTLY
PROGRAMMED
Once you have set your remote control and control your device, you can
blink back your setup code for future reference, even if you used the
Automatic Search Method or the Quick Program Method.
In order to know a specic device code:
1.- Press the button of the programmed device (TV, DVD, etc.).
2.- To know the rst digit, press SET and then press number 1 key.
Count the red blinks on the indicating LED. If there are no blinks, the
digit is “0”.
This kit is ideal for electronic students or hobbyists because
it allows them to develop creativity in the programming of
this prototype of a mechanical system. This kit includes all