Steren RM-8 - Switch Between Devices; Troubleshooting

ENGLISH
ENGLISH-07
3.- For the second digit, press SET and then press number 2 key. Count
the red blinks.
4.- For the third digit, press SET and then press number 3 key. Count
the red blinks.
HOW TO SWITCH BETWEEN DEVICES
Just press the button of the desired device that you want to use (TV,
VCR, Sat, CD, VCD, DVD, Cable, Aux)
TROUBLESHOOTING
TROUBLE SOLUTION
Your brand is not listed in the code section Try the Automatic Search Method.
Try all the codes listed for your brand. Try the Automatic Search
Method
.
Make sure that the correct key was pressed. For example. If you
want to control the TV set, make sure that the TV key was pressed.
You may be using the wrong code. Try the next code listed for your
brand. Start the automatic Search Metho
d
Make sure you are using new batteries and they put on the right
position. Aim the remote control, directly to your device.
Make sure you are using new batteries and they put on the right
position.
The remote control do not operate your device
(s)
The remote control is not performing
commands properly
The remote control does not respond after
pressing a key
The indicating LED does not blink when you
press a key