Why is my Steren TEMP-310 not running scheduled events?
If your Steren Timer isn't running scheduled events, ensure the timer is in automatic mode (AUTO). Also, configure the events in progressive order (for example, power at 8:00 pm, 9:00 p.m. and 10:00 p.m.).
What to do if devices connected to Steren Timer do not turn on?
If devices connected to your Steren Timer aren't turning on, verify that the power supply is working correctly. Also, check the installation for any broken or bad cables and replace them if necessary.
Follow key safety instructions for device operation, including keeping it away from children and avoiding improper use.
Use HOUR and MIN buttons, while holding CLOCK, to adjust the correct hour and minutes.
Press PROG, set ON time, then use DAY button to select day options (daily, weekdays, weekends, alternate).
Press PROG again to set OFF time; repeat steps for additional activation/deactivation events.
Connect device power cords to CH1 (1,2,3) or CH2 (4,5,6) for Normally Open (NO) or Normally Close (NC) options.
Check main power source and wiring for damage. Ensure the main power source AC is working properly.
Set events in progressive time order and ensure the timer is in AUTO modality.
To Next Page
General
