Need help?Do you have a question about the Steris SurgiGraphic 6000 and is the answer not in the manual?
General| Type | Surgical Table |
|---|---|
| Trendelenburg | Yes |
| Reverse Trendelenburg | Yes |
| Trendelenburg Range | 30 degrees |
| Lateral Tilt | Yes |
| Lateral Tilt Range | 20 degrees |
| Back Section Articulation | Yes |
| Leg Section Articulation | Yes |
| Kidney Elevator | Yes |
| Control Type | Hand Control |
| Material | Stainless Steel |
| Weight Capacity | 500 lbs (227 kg) |
| Tabletop Width | 20 inches (51 cm) |
| Tabletop Length | 80 inches (203 cm) |
| Table Height Range | 27 - 44 in (69 - 112 cm) |
Covers various safety hazards including pinch points, tipping, explosion, and personal injury.
Explains safety labels specifically found on the Original SurgiGraphic Table.
Details safety labels applicable to the SurgiGraphic 6000CE Surgical Table.
Provides essential safety warnings related to installation, including pinching, explosion, tripping, and personal injury hazards.
Emphasizes safety during maintenance and provides general guidelines for service procedures.
Outlines a schedule for performing preventative maintenance tasks on the table.
Outlines common table situations, probable causes, and corrective actions.
Guides on installing GX Developer software and setting up a laptop for PLC interaction.
Details saving, loading, and adjusting PLC program parameters for table functions.
Instructions for replacing the PLC battery.
Emphasizes safety warnings before performing component repair or replacement.
To Next Page