2 3
PACK CONTENTS
x Malmo faucet
x Allen key .mm
x Wall rosette
x Set screw M x
x Allen key mm
MALMO
MALMO 1000
x Malmo faucet
x Set screw M x
x Wall rosette
x Temporary
protection cover
x Malmo Base
x Screw
anchors
x
x
x ½”
screws
x Angle
supports
x M x
6 screws
x Allen key mm
PRE-INSTALLATION INFO
CHECK CONTENTS
Separate all parts from the packaging and check each part with the pack contents
section. Pay attention to the variations of the dierent models.
Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic faucet until you
obtain the missing parts.
PREPARATION FOR INSTALLATION
Flush the water supply lines thoroughly before installing the faucet. Do not allow dirt,
teflon tape or metal particles to enter the faucet. Shut o water supply.
IMPORTANT
All plumbing is to be installed in accordance with applicable codes and regulations.
WARNING
) To avoid reflection problems keep
a distance of more than 300 mm.
between the sink and the spout.
) This faucet model, with an infrared
sensor pointing down, is not intended
to be used together with a sink of a
reflective material such as stainless
steel.
) If a sink strainer is straight below
the faucet sensor, use a strainer with
a non reflective nish (do not use a
chrome plated one).
Min mm.
Bottom of the washbasin
To Next Page
Loading...