STERWINS 43PBC1-40BH.1 - First Use Procedures; Operation and Cutting

15
RU
KZ
EN
Remove the line cutting blade cover
NOTE : It is recommended to cover the line blade when your
work is nished.
Remove this cover before you turn on the machine.
Handling and lling the fuel : illustration
3.2
to
3.6
• The engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If oil
is not available, use an antioxidant added quality oil expressly labeled for air-cooled 2-cycle engine use.
RECOMMENDED MIXING RATIO: GASOLINE 40 : OIL 1
• Take care when handling gasoline. Avoid direct contact with the skin and avoid inhaling fuel vapor.
(Refer to assembly manual P.9-P.13).
• Use mid-grade unleaded gasoline with a minimum octane rating of 89 ((R+M)/2).
• Only mix sucient fuel for a few days work, not to exceed 30days of storage. Store in approved fuel-
containers only. When mixing,
1 ) Measure out the quantities of gasoline and oil to be mixed.
2 ) Put some of the gasoline into a clean, approved fuel container. Pour all of the oil in the fuel container.
Pour the rest of gasoline in the oil container and agitate well, then pour the mixture in the fuel container.
3 ) Agitate the fuel container for at least one minute. Put a clear indication on the outside of the container
to avoid confusing it for gasoline or other containers.
WARNING ! A. The fuel is highly ammable. Do not smoke or
bring any ame or sparks near fuel. Clean the fuel cap and
the area around it. FUEL WITH NO OIL(RAW GASOLINE)- It
will cause severe damage to the engine inner parts very
quickly. OIL FOR 4-CVCLE ENGINE USE or WATER COOLED
2-CVCLE ENGINE USE - It can cause spark plug fouling,
exhaust port blocking, or piston ring sticking.
4.3 FIRST USE
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under
subheading therein before using this product.
Pay particular attention using the machine for the rst time : focus and dedicate all your attention to this
rst use. Make the rst trial on a free space with no obstacle and no surrounding element
4.4 OPERATION
Start the product : illustration
4.1
to
4.10
To turn the tool ON, push and hold the safety lock-o button with your thumb, while squeezing the
ON/OFF trigger switch. Once the trigger switch engages, you can release the safety lock-o button and
proceed with operation.
NOTE : The safety lock-o button reduces the risk of accidental starting.
To turn the tool OFF, release the ON/OFF trigger switch.