STERWINS 43PBC1-40BH.1 - Cutting Tips

17
RU
KZ
EN
• Keep rm footing and balance.
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the
footing on slopes.
• Walk, never run. Keep all parts of your body away from any moving part.
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
If the product is dropped, suers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replace by an
authorized service center.
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
4.5 CUTTING TIPS
Check the area you wish to cut and remove any objects that may be thrown up by the blade. Check the
safety equipment on the unit before the start of work. Start the unit. Wear the protective device, use the
harness and hold with your right hand on the operating handle. Gently push down fully on the fuel lever.
Always cut at full speed!
Adjusting the trimming line : illustration
4.30
This unit is equipped with a bump head. Trimming line can be released from the cutting head without
stopping the engine. To release more line, lightly tap the bump knob on the ground while operating
the unit at high speed. For best results, tap the bump knob on bare ground or hard soil. Attempting to
release line in tall grass may stall the engine. Do not rest the cutting head on the ground while the unit is
running. Each time the bump knob is tapped, about 25.4 mm of trimming line is released.
NOTE: Always keep the trimming line fully extended. Line
release becomes more dicult when the cutting line gets
shorter.
Maintaining the trimming line and blade
Hard surfaces, such as sidewalks, can cause the trimming line or blade to wear down quickly or break.
• Frequently check the trimming line length or blade’s surface. Replace the trimming line or blade as
needed.