26
RU
KZ
EN
Problems Probable causes Solutions
Qualication
required
Gasoline leak
There is a leak of gasoline
due to a defective
assembling (drilled pip/bad
connection)
Find the leak location and
replace the part by a new one
After sales
service
Poor trimming
quality
There is no more line on the
spool
Change the line -
The TAP N GO system of the
spool is defective
Change it by a new one -
The blade is damaged
Sharpen it or change it by a
new one
-
The engine lacks
of power
The air lter is dirty
Clean it or replace it by a new
one
-
The spark plug is dirty
Remove and clean the
electrode with a spark plug
brush (iron bristle brush)
-
The gasoline ler is blocked Replace it by a new one
After sales
service
The carburetor speed screw
is not well adjusted
Resume the carburetor setting
procedure from the beginning
After sales
service
The engine
doesn't go to
the idle speed
Gasoline lter is blocked Replace it by a new one
After sales
service
The carburetor idle speed
screw is not well adjusted
Resume the carburetor setting
procedure from the beginning
After sales
service
Motor runs but
the cutting
device doesn't
run
The cutting devise can be to
screwed
Check if you can remove it
easily, try again to start no load
and check if it works
Customer
During the assembly, the
clutch could have been
misplaced
Check the global assembly.
And try again
Customer
*Over current means "Self-protection". This mode is a degraded mode, limited in time (we recommend
a maximum duration of 5 minutes) during which the use of the product is made impossible so that the
product can recover its initial state.
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
To Next Page
Loading...
