a) Have your garden power tool serviced by a qualied repair person
using only identical replacement parts. This will ensure that the safety
of the garden power tool is maintained.
b) If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent in order to avoid a hazard.
C) If the carbon brushes need to be replaced, have this done by a qualied
repair person (always replace the two brushes at the same time).
To reduce the impact of noise and vibration emission, limit the operating
time, use low-vibration and low-noise operating modes, and wear
personal protective equipment.
Take the following points into account to minimise the vibration and
noise exposure risks:
1. Only use the product as intended by its design and these instructions.
2. Ensure that the product is in good condition and well maintained.
3. Use correct attachments for the product and ensure they are in good
condition.
4. Keep tight grip on the handles/grip surface.
5. Maintain this product in accordance with these instructions and keep it
well lubricated (where appropriate).
6. Plan your work schedule to spread any high vibration tool use across a
longer period of time.
Even if you are operating this product in accordance with all the
safety requirements, potential risks of injury and damage remain.
The following dangers can arise in connection with the structure and
design of this product:
2. SAFETY INSTRUCTIONS
VIBRATION AND NOISE REDUCTION
SERVICE
248
FR
ES
PT
IT
EL
PL
RU
UA
RO
EN
To Next Page
Loading...
