7.OPERATION
CAUTION:
gBefore starting the product, make certain the feeding chamber is empty.
gKeep your face and body away from the feed intake opening.
gDo not allow hands, or any other part of the body or clothing inside the feeding chamber,
discharge chute, or any moving part.
gIf the cutting mechanism strikes any foreign objects or if the product should start making
any unusual noise or vibration, immediately shut o the power source and allow the
product to stop.
gDisconnect the power source and inspect for damage or faults.
gBefore operation, adjust the adjusting knob to release any foreign objects which may
interfere with the cutting roller and counter blade.
gSwitch on the tool, then adjust the adjusting knob, you should hear the cutting roller
touching the counter blade.
gThe shredder should produce small metal lings. Tighten the xing knob, make sure the
counter blade is tight.
SET UP THE PRODUCT
On a at, level surface. Do not place the product on graveled ground.
Work at a safe distance (at least 2 meters) away from walls or other objects.
BEFORE STARTING, MAKE SURE THAT:
gThe connection cables are not damaged. If there are cuts or tears, stop operation and
replace it immediately.
gThere is no damage on the product, and all screws are tight.
gThe product is assembled completely and correctly.
Check the mains connection:
gMake sure that the mains voltage matches the rated voltage on the nameplate and the
product is properly grounded.
gUse only extension cords with sucient core cross-section.
The shredder can process the following types of material:
gAll types of branches up to the product’s maximum diameter capacity of 45 mm,
depending on type and condition of the wood.
gDry garden refuse such as plants, which should be dried before shredding and fed
alternately with branches to avoid blocking the shredder.
The shredder can NOT process the following types of material:
gGlass, metal, plastic, stone, ceramics, thicker branches, hard wood, thick wood plates,
cloth, plastic bags, roots with soil.
gRefuse which is in an almost liquid state, e.g. kitchen waste.
OPERATION TIPS
gFeed the material into the lling hopper from the right side.
258
FR
ES
PT
IT
EL
PL
RU
UA
RO
EN
To Next Page
Loading...
