271
2. SAFETY INSTRUCTIONS
EN
rotterubrac eht tpecxe ,swercs dna stlob ,stun lla nethgiT .prahs sedalb peeK •
adjustment screws, before each use.
.sedalb no ecnanetniam gnimrofrep ro gnildnah nehw sevolg raeW •
rotterubrac ehT .gnittes dradnats a htiw yrotcaf eht morf semoc rotterubrac ehT •
ciency in all operating
states. The carburettor shall be only adjusted by authorised person.
cult to start. Clean
always be replaced.
leuf eht dna evlav tnev eht kcehc ,ylppus leuf fo trohs snur enigne eht nehW •
quarters full with grease. The grease in the bevel gear does not normally need
to be changed except if repairs are carried out.
.tnemtsujda rotterubrac tcerrocnI –
.)lio fo epyt tcerrocni ro hcum oot( erutxim leuf tcerrocni nA –
fI the engine is
cult to start or runs poorly at idling speed,
hours or earlier if the electrodes are badly eroded. Clean the spark plug if it
is dirty. Check the electrode gap and readjust if necessary. The recommended
clearance of the gap is 0.6-0.7 mm. Always use the recommended spark plug
type! Use of the wrong spark plug can damage the piston/ cylinder.
ot stcapmi rehto ro gnippord retfa dna esu erofeb yliad enihcam eht tcepsnI •
To Next Page
Loading...
Need help?
General
