StetSom DB3000 - LED Indicators and Protection System; Smart Protection System Codes

14
LED indicators
POWER (blue LED): 
when it is on.
PROT (top red LED):    

it to shut down. Use the protecon table below to

on again.
CLIP (lower red LED): Indicates that there is signal

Problem: Short circuit or output overload.
Soluon: Make sure that the speaker cables are well
isolated. Verify the minimum impedance supported.
Soluon: Verify that the amplier is in a well-venlated
place and that the coolers are not obstructed.
Problem: Overheang
Soluon: Baery consumpon is normal when using
the amplier. Recharge the baery.
Soluon: Verify the power supply/baery system.
Problem: Low baery.
Problem: Tension higher than allowed.
Smart protection system
PROT LED


1 x
2 x
3 x
4 x