List of contents
1 Operating instructions for the user and the qualified installer 18
1.1 Unit description ____________________________________________________________ 18
1.2 The main features in brief _______________________________________________ 18
1.3 Safety instruction __________________________________________________________ 18
1.4 Important information ____________________________________________________ 18
1.5 Hot water output ___________________________________________________________ 18
1.6 Thermal cut-out ____________________________________________________________ 18
1.7 External remote operation ______________________________________________ 18
1.8 Recommended setting ____________________________________________________ 18
1.9 First Aid in the event of faults __________________________________________ 18
1.10 Care and maintenance ____________________________________________________ 18
1.11 Instructions for Installation and Use __________________________________ 18
2 Installation instructions for the qualified installer ______________ 19
2.1 Brief description ___________________________________________________________ 19
2.2 Important information ____________________________________________________ 19
2.3 Instructions and regulations ____________________________________________ 19
3 Standard installation for the qualified installer _________________ 20
3.1 General installation information _______________________________________ 20
3.2 Place of installation _______________________________________________________ 20
3.3 Equipment preparation for installation _______________________________ 20
3.4 Securing the mounting bracket
F
____________________________________ 20
3.5 Trimming the power cable to size ______________________________________ 20
3.6 Equipment installation
F
_______________________________________________ 20
3.7 Water connection
G
_____________________________________________________ 20
3.8 Electrical connection ______________________________________________________ 20
3.9 Completing the installation ______________________________________________ 20
3.10 Initial start-up ______________________________________________________________ 20
4 Installation alternatives for the qualified installer ______________ 21
4.1 Mounting bracket when equipment is replaced
J
________________ 21
4.2 Electrical connection – finished walls _________________________________ 21
4.3 Electrical connection – from above
L
_______________________________ 21
4.4 Rotated equipment cap __________________________________________________ 21
4.5 Installation of cable grommet __________________________________________ 21
4.6 Priority control
O
________________________________________________________ 21
4.7 Compression fittings – finished walls _________________________________ 21
4.8 Soldered fitting – finished walls________________________________________ 21
4.9 Installing lower part of back panel ____________________________________ 21
4.10 Offset installation for tiled surfaces ___________________________________ 21
4.11 Operation with pre-heated water ______________________________________ 22
4.12 Temperature cut-out
M
_________________________________________________ 22
5 Installation alternatives for the qualified installer ______________ 22
5.1 Details on energy consumption ________________________________________ 22
5.2 Technical Data (The data on the unit rating plate apply) __________ 23
5.3 Area of application ________________________________________________________ 23
6 Troubleshooting by the user and the qualified installer ________ 24
6.1 Display options LED diagnostic „traffic lights“ ______________________ 24
6.2 Fault table ___________________________________________________________________ 24
7 Special accessories _________________________________________________ 25
8 Warranty | Environment and Recycling ___________________________ 25
To Next Page
Loading...
