25
Remote controls for DEL…SLi
The radio remote controls are operated by
means of wireless user interfaces. Perfect
communication is guaranteed up to 25 m in
buildings. The instantaneous water heater
can be operated with a maximum of 6 radio
remote controls.
The control unit on the equipment only shows
the temperature set in the remote control, it
can not adjust the temperature!
• FFB 1 – Radio remote control
Operation from two locations:
Equipment and radio remote control.
Accessory: radio remote control (transmit-
ter), connection module (receiver) and wall
mount.
• FFB 2 – Radio remote control
Radio remote control as an extension of
FFB 1
Accessory: radio remote control (transmit-
ter) and wall mount.
Two-handle pressure valves
• Kitchen valve WKMD
• Bath valve WBMD
Installation accessories
• Under-worktop set – unfinished walls
Connections for finished walls, G 3/8”, top
• Set 2x water plugs G ½
Required with third party pressure valves
(
P
a).
Note:
Not required for Stiebel Eltron valves WKMD
and WBMD.
• Installation set for finished walls
Solder fitting – copper pipe:
Part no. 07 40 19 (
Q
a)
comprising:
– 2 x water plug G ½”.
– 2 x union nut ½” with insert for solder
fitting Ø 12 mm.
Compression fitting – copper pipe:
– 2 x water plug G ½”.
– 2 x compression fitting ½” x 15 mm, plus
gaskets.
Compression fitting – plastic pipe:
– 2 x water plug G ½”.
– 2 x compression fittings ½” x 16 mm
(Viega: Sanfix-Plus or Sanfix-Fosta), plus
gaskets.
• Universal mounting frame
consisting of:
– mounting frame with
– electrical wiring
This set creates a gap of 30 mm between
the equipment back wall and the instal-
lation wall.
This enables the electrical connection
to be routed over unfinished walls at
any point behind the equipment. It in-
creases the equipment depth by 30 mm
and reduces the protection level to IP 24
(splash-proof).
• Offset installation – unfinished walls
consisting of:
– universal mounting frame.
– pipe bends for vertical displacement of the
equipment by 90 mm downwards compared
to the water connection.
• Gas water-heater replacement set
consisting of:
– universal mounting frame.
– pipe bends for installation at existing gas
water-heater connections (cold water left
and hot water right).
• Load circuit breaker LR 1-A
Priority control of the DEL… for simultane-
ous operation of e.g. electric storage hea-
ters. For connection of the LR1-A, see
O
.
• Accessories for operation of a DEL ... with
pre-heated water
ZTA 3/4 – central thermostatic valve
By adding cold water via a bypass pipe, the
central thermostatic valve installed imme-
diately above the storage water cylinder
guarantees that the outlet temperature of
60 °C is not exceeded.
• Service monitor
Diagnostic unit for fault recognition in the
DEL ...
e
l
e
c
t
r
o
n
i
c
c
o
m
f
o
r
t
electr
oniccomf
ort
e
le
c
t
r
o
n
i
c
c
o
m
f
o
r
t
26_02_02_0633
8. Warranty | Environment and Recycling
Guarantee
The guarantee conditions of our German companies do not
apply to appliances acquired outside of Germany. In countries
where our subsidiaries sell our products a guarantee can only
be issued by those subsidiaries. Such guarantee is only grant-
ed if the subsidiary has issued its own terms of guarantee. No
other guarantee will be granted.
We shall not provide any guarantee for appliances acquired in
countries where we have no subsidiary to sell our products.
This will not aect warranties issued by any importers.
Environment and recycling
We would ask you to help protect the environment. After use,
dispose of the various materials in accordance with national
regulations.
To Next Page
Loading...
