INSTALLATION
Installation
40 | DEM www.stiebel-eltron.com
Appliance installation
Note
The wall must have sufficient load bearing capacity.
f Mount the appliance on the wall.
26_02_05_0083
f Undo the cover fixing screws by two turns.
f Undo the snap fastener using a screwdriver.
f Remove the appliance cover with the heater towards the
front.
f Using pliers, break out the knock-out for the power cable
in the appliance cover. Correct the contours with a file if
necessary.
26_02_05_0084
f Use the appliance back panel as a drilling template.
f Secure the appliance back panel to the wall with suitable
rawl plugs and screws.
26_02_05_0085
To Next Page
Loading...
