STIEBEL ELTRON DEM 3 - Page 41

ENGLISH
www.stiebel-eltron.com DEM | 41
INSTALLATION
Installation
f Route the power cable through the knock-out in the back
panel.
f Hook in the appliance cover with the heater at the bottom.
f Click the heater into place using the snap fastener.
f Secure the appliance cover with the cover fixing screws.
Tap installation
!
Property damage
f When making the connections, counterhold the
torque on the appliance using a size 14 spanner.
f Install the tap. For this, also observe the tap operating and
installation instructions.
Pressure-tested tap
Note
f Fit the 3/8connection hose and the 3/8tee provided.
10.2.2 Oversink installation, non-pressurised, with non-
pressurised tap
26_02_05_0081_
Tap installation
!
Property damage
f When making the connections, counterhold the
torque on the appliance using a size 14 spanner.
f Install the tap. For this, also observe the tap operating and
installation instructions.
Appliance installation
f Fit the appliance to the tap with the water connections.