STIEBEL ELTRON DHE Connect 18 User Manual

INSTALLATION
Appliance description
80 |DHEConnect | DHETouch www.stiebel-eltron.com
- Wall mounting bracket and adhesive pad
8.2 Accessories
Wireless remote controls
- FFB W Set
- FFB T Plus SetEU
- FFB T Set
- FFB T Plus SetEU
- FFB4EU
Taps/valves
- MEKD mono lever kitchen pressure tap
- MEBD mono lever bath pressure tap
Plug G½A
If you use other than the recommended pressure taps on finished
walls, please use the plugs.
Installation set for finished walls
- Solder fitting - copper pipe for soldered connection Ø 12 mm
- Compression fitting - copper pipe
- Press-fit fitting - plastic pipe (suitable for Viega: Sanfix-Plus
or Sanfix-Fosta)
Universal mounting frame
- Mounting frame with electrical connections
Pipe assembly for undersink appliances
You will need the undersink installation set if you make the water
connections (G⅜A) at the top of the appliance.
Pipe assembly for offset installation
Use this pipe assembly if you intend to offset the appliance by up
to 90mm downwards from the water connection.
Pipe assembly for replacing a gas water heater
You will need this pipe assembly set if the existing installation
has gas water heater connections (cold water connection on the
left-hand side, DHW connection on the right-hand side).
Pipe assembly for DHB water plug-in couplings
Use the water plug-in couplings if the existing installation contains
water plug-in connections from a DHB water heater.
Load shedding relay (LR 1-A)
The load-shedding relay for installation in the distribution board
provides priority control for the instantaneous water heater when
other appliances, suchas electric storage heaters, are being op-
erated simultaneously.

STIEBEL ELTRON DHE Connect 18 Specifications

General

Brand	STIEBEL ELTRON
Model	DHE Connect 18
Category	Water Heater
Language	English