EasyManuals Logo

STIEBEL ELTRON DHF 13 C-AU User Manual

STIEBEL ELTRON DHF 13 C-AU
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6 | DHF C-AU www.stiebel-eltron.com
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
!
Material losses
Observe the maximum inlet temperature. Higher tem-
peratures may damage the appliance. You can limit the
maximum inlet temperature by installing a central ther-
mostatic valve.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
Protection rating IP 24 (splashproof) can only be guaranteed with
a correctly fitted cable grommet.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
- Installation template (in the centre section of these
instructions)
- 2 extensions
- 2 caps
- 2 tees
- 2 plugs
- 8 flat gaskets
- Strainer
- Plastic profile washer
- 2 cover guides (for installation on finished walls)
9. Preparations
9.1 Installation site
!
Material losses
Install the appliance in a room free from the risk of frost.
Always install the appliance vertically near the draw-off
point.
The appliance is suitable for undersink and oversink installations.
Note
Mount the appliance on the wall. The wall must have
a sufficient load-bearing capacity.
Undersink installation
D0000042705
1
2
1 Cold water inlet
2 DHW outlet
Oversink installation
D0000042706
12
1 Cold water inlet
2 DHW outlet
9.2 Water installation
- Never operate with preheated water.
- A safety valve is not required.
Flush the water line thoroughly.
Ensure that the flow rate (see chapter "Specification/ Data
table", On) for switching on the appliance is achieved. In-
crease the mains water pressure if the required flow rate is
not achieved with the draw-off valve fully opened.
Taps/valves
Use appropriate pressure taps. Open taps are not permitted.

Other manuals for STIEBEL ELTRON DHF 13 C-AU

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the STIEBEL ELTRON DHF 13 C-AU and is the answer not in the manual?

STIEBEL ELTRON DHF 13 C-AU Specifications

General IconGeneral
BrandSTIEBEL ELTRON
ModelDHF 13 C-AU
CategoryWater Heater
LanguageEnglish

Related product manuals