34 | DHM www.stiebel-eltron.com
INSTALLATION
Preparations
8.2 Accessories
Special aerator "SR"*
- SR 3: Part number 289591
for DHM 3 and DHM 4
- SR 5: Part number 270582
for DHM 6 and DHM 7
* For use in thread M22/M24.
Pressure-tested tap
- WEH Sensor tap for washbasins
Non-pressurised taps
- WEN Sensor tap for washbasins
- MAZ Twin lever basin tap
- MAE Mono lever basin tap
ZTA 3/4 - central thermostatic valve
Thermostatic valve for central premixing, for example for operat-
ing an instantaneous water heater with a solar thermal system.
9. Preparations
Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
Use suitable taps (see chapter "Appliance description/
Accessories").
Note
Fitting the special aerator supplied provides an optimum
water jet.
10. Installation
10.1 Installation site
Install the appliance in a room free from the risk of frost and near
the draw-off tap.
Ensure that the lateral fixing screws for the cover are always
accessible.
The appliance is only suitable for undersink installation (water
connections at the top).
To Next Page
Loading...
