STIEBEL ELTRON DHM 3 - Page 46

46 | DHM www.stiebel-eltron.com
INSTALLATION

DHM 3 DHM 4 DHM 6 DHM 7
Values
Max. permissible inlet temperature °C 35 35 35 35
On l/min >1.6 >2.0 >2.6 >2.6
Pressure drop at flow rate MPa 0.05 0.06 0.08 0.08
Flow rate for pressure drop l/min 1.6 2.0 2.6 2.6
Flow rate limit at l/min 2.2 2.8 4.3 4.3
DHW primary pump l/min 2.0 2.5 3.2 3.7
Δϑ if presented K 25 25 25 25
Hydraulic data
Nominal capacity l 0.1 0.1 0.1 0.1
Versions
Undersink installation X X X X
Open vented type X X X X
Sealed unvented type X X X X
IP rating IP25 IP25 IP25 IP25
Safety category 1 1 1 1
Insulating block Plastic Plastic Plastic Plastic
Heating system Bare wire Bare wire Bare wire Bare wire
Cap and back panel Plastic Plastic Plastic Plastic
Colour White White White White
Dimensions
Height mm 143 143 143 143
Width mm 190 190 190 190
Depth mm 82 82 82 82
Weights
Weight kg 1.4 1.4 1.4 1.4