STIEBEL ELTRON VRC-W 400 - Menus

OPERATION
Settings
ENGLISH
www.stiebel-eltron.com VRC-W 400 (E) | 7
Direct selection parameters
VRC-W 400 VRC-W 400 E
Description Code
level
Unit Min. Max. Options Stand-
ard
Min. Max. Options Stand-
ard
P1 Set room temperature A0 °C 5 28 20 5 28 20
P2 Intens. vent. time A0 min. 1 240 30 1 240 30
P3 Operating mode heat recovery
bypass
A0 Disabled (0)|
Bypass/window contact (1)|
Outdoor air routing automatic(2)|
Extract air routing autom. (3)
(2)
Disabled (0)|
Bypass/window contact (1)|
Outdoor air routing automatic(2)|
Extract air routing autom. (3)
(2)
P4 Filter reset A0 Off | On Off Off | On Off
P28 Enable fan A0 Off | On Off Off | On Off
P35 Cooling/heating, heat recovery
bypass
A0 Cooling/heating (1)|
Cooling (2)|
Heating (3)
(1) Cooling/heating (1)|
Cooling (2)|
Heating (3)
(1)
P80 Day A0
P81 Time A0 00:00 23:59 00:00 23:59
4.4 Menus
Note
Some parameters are protected by a code and can only
be set by a qualified contractor or the service department.
Depending on the set code, not all parameters may be
displayed in the individual menus.
f Press the "MENU" button to access the menus from the home
screen.
Menu Description
 Info Information about the actual values of the unit
 Diagnostics Fault messages, operating time, maintenance intervals
 Programs Fan program
 Settings Adjustable values and functions
4.4.1 "Info" menu
 Info
Value
 Bypass status Off | On
 Extract air temp. °C
 Extract air hum. %
4.4.2 "Diagnostics" menu
 Diagnostics
Value
 Notification list Off | On
 Filter runtime h
 Filter reset Off | On
Diagnostics
 Notification list
The faults most recently registered by the unit are stored in the
notification list. The most recent fault is stored in #1, the oldest
error in #10.
If no faults are entered, dashes are shown. Possible faults are
listed for qualified contractors in the "Troubleshooting" chapter.
 Filter runtime
The filter runtime is dependent on the operating conditions and
has been defined by the qualified contractor.
 Filter reset
f After changing the filters, set the "Filter reset" to "On".
The unit resets the filter runtime to 0 and the "Filter reset" is au-
tomatically reassigned the value "Off". The filter change warning
signal goes out.
344462-45598-9853_VRC-W_400_E_en_fr_it_nl.indb 7344462-45598-9853_VRC-W_400_E_en_fr_it_nl.indb 7 07.07.2023 16:59:5707.07.2023 16:59:57