STIEBEL ELTRON VRC-W 400 - Page 9

OPERATION
Settings
ENGLISH
www.stiebel-eltron.com VRC-W 400 (E) | 9
4.4.4 "Settings" menu
 Settings
Value
 View Code for qualified contractor
 General
 Time/date Day
Hour:Minute
 Language German
English
Francais
Nederlands
Italiano
Polski
Cesky
Magyar
Slovensko
中文
Slovensky
日本語
 Contrast 1 - 10
 Brightness %
 Touch sensitivity 1 - 10
 Touch boost 1 - 10
 Prog. unit software
 Air flow rate Only for qualified contractors
 Favourites
 F1
F2
F3
Bypass status
Extract air temp.
Extract air hum.
Filter runtime
Device software version
Device software patch
Term. device serial no.
 Humidity prot. Only for qualified contractors
 Intensive ventilation
 Intens. vent. time min
 Heat recovery bypass
 Set room temperature °C
 Operating mode heat recovery bypass Disabled
Bypass/window contact
Outdoor air routing automatic
Extract air routing autom.
 Cooling/heating, heat recovery bypass Cooling/heating
Cooling
Heating
 Frost protection Only for qualified contractors
 Condensate prevention Only for qualified contractors
 Enable fan Off
On
 Ventilation unit
 Device software version
 Device software patch
 Term. device serial no.
Settings
 View
The only parameters displayed in the standard setting are those
that have been released for the appliance user and can therefore
be accessed without a code
Qualified contracts can use the "View" parameter to enable actual
values and parameters, which are reserved for qualified contrac-
tors.
 General
 Time/date
The "Time/date" parameter enables you to set the day of the week
and the current time.
 Language
The "Language" parameter enables you to select the language of
the display.
 Contrast
The "Contrast" menu item allows you to adjust the contrast of
the display.
 Brightness
The "Brightness" menu item allows you to set the brightness of
the display.
 Touch sensitivity
The "Touch sensitivity" parameter enables you to adjust the touch
sensitivity of the Touch-Wheel and the sensor keys.
 Touch boost
The "Touch boost" lets you adjust the reaction speed of the Touch-
Wheel and the sensor keys.
 Favourites
In the "Favourites" parameter, you can select up to three parame-
ters that you wish to have displayed in the standard display.
 Intensive ventilation
 Intens. vent. time
This parameter defines the runtime for intensive ventilation. After
this time has expired, the unit switches back to the previously
selected fan setting. If the intensive ventilation is switched on
with an external pushbutton, this parameter defines how long
the intensive ventilation continues to run after the button has
been pushed.
 Heat recovery bypass
 Set room temperature
Use this parameter to specify the outside temperature from which
the outdoor air bypasses the heat exchanger by being routed
through the bypass damper and directly into the building.
f Use the Touch-Wheel to set the required Set room tempera-
ture. Press "OK".
344462-45598-9853_VRC-W_400_E_en_fr_it_nl.indb 9344462-45598-9853_VRC-W_400_E_en_fr_it_nl.indb 9 07.07.2023 16:59:5707.07.2023 16:59:57