OPERATION
Maintenance and care
22 | WPC | WPC cool www.stiebel-eltron.com
6. Maintenance and care
!
Appliance and system damage
Maintenance work, such as checking the electrical safety,
must only be carried out by a qualified contractor.
A damp cloth is sufficient for cleaning all plastic and sheet metal
parts. Never use abrasive or corrosive cleaning agents.
We recommend an annual inspection (to establish the system's
current condition), and maintenance by a qualified contractor if
required (to return the system to the desired condition).
7. Troubleshooting
Fault Cause
Remedy
There is no hot water or
the heating system stays
cold.
The fuse/MCB has blown/
responded.
Check the fuses/MCBs in
your fuse box.
7.1 Other problems
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate. The type plate is located at the front
top, on the right or left hand side of the casing.
Sample type plate
Montageanweisung beachten! Dichtheit geprüft!
Made in Germany
*xxxxxxxxxxxxxxxxxx*
1
26�03�01�1570
1 Number on the type plate
To Next Page
Loading...
Need help?
General
