INSTALLATION
Installation
www.stiebel-eltron.com WPE-I H(K) 230 Premium | 9
9.2 Siting
Remove the packaging film and the top and side EPS pad-
ding.
Tilt the appliance forwards slightly.
Place wooden blocks underneath the back of the appliance.
Tilt the appliance backwards slightly and remove it from the
EPS pallet. To do this, use the handles provided at the back
and the front adjustable rubber feet at the bottom.
Position the appliance on the prepared substrate.
Observe minimum distances (see chapter "Preparations/
Minimum clearances").
Level the appliance horizontally by adjusting the feet.
9.3 Removing the casing parts
Note
When you open the appliance, check the sealing tape.
The sealing tape is required for generating the necessary
negative pressure.
Replace the sealing tape if required.
1.
2.
D0000082700
Remove the screws on both sides of the appliance.
Slide the handles on both sides of the appliance along the
guide as far as they will go.
Removing the cover
1.
2.
D0000082699
Pull the cover forwards.
Hang the cover down in front of the appliance.
Removing the front panel
D0000082698
Remove the front panel by pulling it towards the front.
Removing the side casing
D0000088163
Remove the front panel (see "Removing the front panel").
Remove the screws.
Pivot the side casing to the side.
If necessary, lift the side casing out of the rear hinges. Pay
attention to any electrical cables.
To Next Page
Loading...
