STIEBEL ELTRON WWK 222 - Adjusting the Settings

OpEraTiON
Settings
10 | WWK222-302 H www.stiebel-eltron.com
4.4 Adjusting the settings
The default display shows the mixed water volume.
The "Menu" button allows you to call up
all information and adjustment options in
sequence. The relevant symbol appears.
 Menu
 Mixed water volume display
 Actual temperature display
 Set temperature 1
 Set temperature 2
 Fan speed
 Air intake temperature display
 Enable the “Runtime-dependent rapid
heat-up” function
In appliances with no electric
emergency/booster heater,
this parameter has no func-
tion.
 Time set for the “Runtime-dependent
rapid heat-up” function
In appliances with no electric
emergency/booster heater,
this parameter has no func-
tion.
 Change units
 Charge level
 Fault code
 E fault code
 Advanced menu (with service plug only)
 Integral sensor offset
 Set the cylinder volume
 Compressor lockout due to evaporator
fault
 Clear high pressure lockout
 Clear low pressure lockout
 Temperature of evaporator fins
 Number of times hot gas temperature
sensor was triggered
 Number of defrost faults
 Number of low pressure triggers
 Number of high pressure triggers
 Hot gas temperature switching value
 Fan lead time
 Integral sensor replacement
 Set value limit
Menu
 Mixed water volume display
The currently available mixed water
volume at 40°C and at 15°C cold water
temperature is shown.
"--L" is shown if less than 10l mixed
water is currently available.
DHW demand for Mixed water volume at 40°C
Bath 120-150 l
Shower 30-50l
Washing hands 2-5l
The mixed water volume that can be achieved depends on the
cylinder size and the set temperature selected.
 Actual temperature display
In the "Mixed water volume" menu, press
"Menu" once to access the "Actual tem-
perature" menu.
The "Actual temperature" symbol ap-
pears.
The current actual temperature is shown.
The actual temperature is the tempera-
ture in the upper section of the DHW cyl-
inder, and therefore largely corresponds
to the outlet temperature.
 Set temperature1
Note
For hygiene and other reasons, only change this value if
instructed by Stiebel Eltron representative..
Set temperature1 is the DHW temperature to which the appliance
regulates if no external signal transmitter is connected and active.
Factory setting
Set temperature 1 °C 1
In the "Actual temperature" menu, press
"Menu" once to access the "Set temper-
ature1" menu.
The set temperature1 symbol appears.
You can change the value using the "Plus"
and "Minus" buttons. Setting range: 61
- 65 °C