STIEBEL ELTRON WWK 222 - Fault Conditions

iNSTallaTiON
Specication
www.stiebel-eltron.com WWK222-302 H | 37
A1 Electronic assembly (control unit)
A2 Electronic assembly (programming unit)
A3 Electronic assembly (electrical corrosion protection)
C1 Capacitor
C2 Battery pack
E1 Heating element
F1 High limit safety cut-out TSR
F2 Motor overload relay M1
F3 High pressure switch
F4 Fuse
F5 Fuse
G1 Impressed current anode
M1 Compressor
M2 Fan
N1 Thermostat TSR
R1 Resistor
S1 DIP switch (operating mode)
S2 DIP switch
T1 Temperature sensor cylinder top/int.
T2 Temperature sensor, hot gas
T3 Temperature sensor, air intake
T4 Temperature sensor, evaporator
V1 Solenoid valve (live in heating mode)
V2 Solenoid valve (live in defrost mode)
X0 Mains terminal
X1 Terminal
X3 Terminal
X4 Terminal, battery pack
16.3 Fault conditions
WARNING Burns
In the case of a fault, temperatures up to the high limit
safety cut-out limit can occur (see chapter "Specifica-
tion/ Data table").