Stiga A 3000

30 EN
4. INSTALLATION
4.5.1. INSTALLATION OF THE CHARGING BASE
CAUTION:
Danger of cutting hands.
CAUTION:
Danger of dust in
the eyes.
ELECTRICAL HAZARD:
Connect the power supply only at the end of
all the installation operations. If necessary

power supply.
Requirements and obligations:
• Flat land • Compact soil
• charging base • Fixing screws
• Power supply • Gloves
• Glasses
GLOVES OBLIGATION:
Use protective gloves to avoid
cutting your hands.
GLASSES OBLIGATION:
Use safety glasses to avoid the
danger of dust in the eyes.
The charging base can be installed inside the work area or in an area connected to it by a transition route.
Make sure that the space for installing the charging base is sucient, in order to have an obstacle-free
zone at least 1.5 metres wide and at least 3 metres long in front of it.
Procedure:
1. Check the installation requirements as indicated in par. 4.3.
2. If necessary, prepare the ground so that the surface of the charging base (A) is at the same level
as the lawn (B), the ground must be perfectly at and compact in order to avoid deformation of the
surface of the charging base.
B
A