65EN
7. TROUBLESHOOTING
The working area is not
mowed completely.
Insucient working hours. Extending the working hours (See
Par. 4.7.12).
Cutting device with encrustations
and / or residues.
Switch o the robot lawn mower in safety
conditions (See Par. 2.3). Clean the
cutting device.
Pivoting cutting blades blocked by
encrustations or residues.
Switch o the robot lawn mower in safety
conditions (See Par. 2.3). Replace the
cutting blades.
The working area is too large for
the robot lawn mower's capacity.
Reduce the work area (see Technical
Data Par. 1.2).
Batteries about to exhaust their
life cycle.
Replace the batteries with original spare
parts (See Par. 6.4).
Batteries are not charged
completely.
Clean and eliminate any oxidation
from the contact points (See Par. 6.2).
Recharge the batteries.
The charging base light
does not turn on when
the robot is out of the
charging base.
The supply voltage is missing
or there is a fault in the charging
base.
Check that the power supply unit is
plugged in correctly. Check the integrity of
the power supply connection cable.
The charging base
indicator lights up
ashing slowly.
The charging base was not set up
correctly.
Set up the charging base through the app.
(See Par. 4.7.5).
The charging base
indicator light ashes
rapidly.
There is a fault in the charging
base.
Disconnect the charging base from the
mains and reconnect it after a few
minutes. If the problem persists, contact a
service centre.
The charging base
indicator lights up
ashing twice or three
times rapidly.
The charging base has detected
a short circuit on the charging
contacts.
Disconnect the charging base from the
mains, rectify any short circuits and clean
the charging contacts of the charging
base and the robot. Reconnect the
charging base to the mains. If the problem
persists, contact a service centre.
The Warning icon lights
up on the keypad.
It indicates anomaly / failure
conditions.
See the app for more information or
contact a service centre.
The robot lawn mower
stops temporarily in the
work area.
Weak GPS signal. If the problem persists, please contact an
authorised dealer.