32EN
5. The motor shuts down whilst working
6.
The blades do not engage or do not stop
promptly when they are disengaged
7. Uneven cut
8. Unusual vibrations while working
9. Uncertain or ineffective braking
10. Erratic forward movement, poor drive
when going uphill or if the machine has
a tendency to rear up
11. With the engine running, the machine does
not move when the drive pedal is pressed
(for hydrostatic drive models)
– the safety devices have cut in
– fuse blown (10 A)
– problems with engagement mechanism
– cutting deck not parallel to the ground
– blade cuts badly
– cutting deck is full of grass
– blades are unbalanced or loose
– bolts and screws are loose
– the brake is not adjusted correctly
– problems with the belt or the engagement
device
– move the disengagement lever to position
«B»
– check that the conditions allowing starting
are met ( 5.2.b)
– replace the fuse (10 A) ( 6.3.5)
– contact Your Dealer
– check pressure and the external diameter of
the tyres ( 6.3.1) or contact your Dealer
– contact Your Dealer
– clean the cutting deck ( 5.4.8)
– contact Your Dealer
– check and tighten all the engine and frame
bolts
– contact Your Dealer
– contact Your Dealer
– move it to position «A» ( 4.33)
PROBLEM LIKELY CAUSE SOLUTION
If problems continue after having carried out these operations, contact your dealer.
Do not take on complicated repair work if you don't have the necessary equipment or the techni
cal
knowledge. The warranty is automatically voided and the manufacturer is not held responsible if repairs are done
badly.
WARNING!
To Next Page
Loading...
Need help?
General
