Lubrication of auger shaft
Replacement of the engine oil
*** Interventions which must be carried out by your dealer or an authorised assistance centre
12. PROBLEM IDENTIFICATION
Ignition key not inserted.
Fill the tank with quality, pure fuel.
Wait a few minutes before starting.
Do not press the primer bulb
and disconnect the choke.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Fuel tank cap covered with ice or snow.
Remove ice or snow from over
and around the tank cap
3. Engine rotates at
the minimum or
operates irregularly
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Carburettor needs replacing
Contact the authorised assistance centre.
Loose parts or auger or rotor damaged.
Tighten all the fastening devices.
Replace the damaged parts in the
authorised assistance centre.
Handle not correctly positioned.
Ensure the handle is fastened in its position.
5. Loss or slowing of
thrown snow
Clean the discharge chute.
Remove any dirt or foreign
bodies from the auger.
Traction drive command cable
not correctly adjusted.
Contact the authorised assistance centre.
If problems persist after having performed the above operations, contact your dealer.