37EN
3. INSTALLATION
3.7.9.
The “Go-to-Cut Points” section allows you to set one or more starting points for the robot lawn mower's
work in order to improve coverage in the dierent areas of the garden (see Par. 3.4). The number of start
points that can be set depend on the robot lawn mower model and the battery type.
The work start points are dened using the following parameters:
• Distance from the starting point to the charging base measured along the perimeter wire.
• Direction to reach the work point (clockwise or anticlockwise).
• Frequency of reaching the work point expressed in% of the total programmed work time.
The setting of the cut points can be performed through an automatic acquisition procedure:
1. Place the robot lawn mower on the charging base.
2. Access the menu (A) and follow the guided procedure: press the button (B) to start the acquisition of
work start points. The robot lawn mower starts following the cable.
3. Press the button (C) to stop the robot lawn mower at the chosen starting point.
4. Press the button (D) to acquire the distance.
5. To acquire subsequent work start points press the button (E) and repeat the procedure of the points
(3) and (4).
6. Once you have acquired all the points, press the button (F) to nish the procedure. The robot lawn
mower will complete the route to the charging base by automatically establishing the shortest route
(clockwise or anticlockwise) to reach the points set during the work.
The automatically acquired parameters can be changed manually by the user (G).
The frequency of reaching each point must be set by the user (H).
A
DC F G HEB
To Next Page
Loading...
Need help?
General
