6
IMPORTANT Do not work on slopes
exceeding 20° to avoid compromising
correct engine operation
5.5 STOPPING THE ENGINE
DURING WORK STAGES
1. Move the throttle lever to
2.
least 15-20 seconds.
3.
5.6 STOPPING THE ENGINE AT
THE END OF OPERATION
1. Move the throttle lever to
2.
least 15-20 seconds.
3.
4.
5.
5.7 CLEANING AND STORAGE
•
•
•
5.8 PROLONGED DOWNTIME
•
all of the fuel in a suitable container. At
•
6. MAINTENANCE
Any attempt to tamper with the
emission control system may increase
emission levels above legal limits.
This denition includes the removal or
alteration of parts such as the intake system,
the fuel system and the exhaust system.
6.1 GENERAL INFORMATION
The safety regulations that must
be followed during maintenance
are described in par. 2.4.
All controls and maintenance
operations must be carried out with
the machine o and the engine o.
Disconnect the spark plugs and read the
relative instructions before starting any
cleaning or maintenance procedure. Wear
suitable clothing, gloves and glasses
before performing any maintenance.
•
• The use of non-original parts and accessories
•
Authorised Assistance Centres and Dealers.
IMPORTANT All maintenance and
adjustment operations that are not described
in this manual must be carried out by your
Dealer or by an Authorised Service Centre.
6.2 MAINTENANCE TABLE
IMPORTANT It is the responsibility of the
owner to perform the machine maintenance
operations described in the table below.
IMPORTANT Clean more frequently when
operating in particularly demanding conditions or
when there is debris in the air.
NOTE Filters should be cleaned / replaced
more often if the machine is used on very dusty
ground.
To Next Page
Loading...
