ZT 3107 T
Chapter
7 - ELECTRICAL SYSTEM
2017
WARNING! -Make sure the cables are clear of any moving engine parts before start-
ing the engine.
7.2.3 Switches
NOTE Check that the connections to the switches are stable and that the switch is actuated
correctly before performing an electrical test (Safety switches may need adjusting in order to be
actuated correctly).
IMPORTANT During the check process, remove the switches from their respective circuit, un-
plugging the connector. If the cables are left in place, the machine components or the meter may
be damaged.
a) Normally Open Switch
To Next Page
Loading...
