Stihl 200 - Harness Fitting and Storage; Fuel Pickup Body Replacement; Long-Term Storage Procedure; Shoulder Strap Harness Fitting

31FS 120, FS 200, FS 250
English
Change the fuel pickup body every
year.
Before storing your machine for a long
period, drain and clean the fuel tank.
Run the engine until the carburetor is
dry.
Shoulder strap*
: Put on the shoulder strap (1).
: Adjust the length of the strap so that
the spring hook (2) is about 2” below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
* see “Guide to Using this Manual”
Full harness*
: Put on the full harness (1).
: Adjust length until the spring hook
(2) is about a hand’s width below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
* see “Guide to Using this Manual”
256BA061 KN
Fitting the Harness