37FS 120, FS 200, FS 250
English
: Remove the filter element and
inspect it – replace if dirty or
damaged – do not clean.
: Install filter element in the cover.
: Refit the filter cover.
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
General Information
The carburetor comes from the factory
with a standard setting.
This setting is designed to provide an
optimum fuel-air mixture under most
operating conditions.
With this carburetor it is only possible to
adjust the engine idle speed within fine
limits.
Motor Management Adjusting the Carburetor
LA
H
L
1
250BA039 KN
To Next Page
Loading...
