Stihl 350 - Adjusting the Throttle Cable

21FS 300, FS 350, FS 400, FS 450, FS 480
English / USA
Some machine versions are equipped
with a throttle cable adjuster in the
control handle.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
Adjusting the Throttle Cable
002BA163 KN
STOP
249BA017 KN
1
2