TS 410, TS 420
English
11
Cut in several passes
N Mark cutting line (A)
N Work along the cutting line. When
making corrections, do not tilt the
cutting wheel, but always set the
cutting wheel against the workpiece
anew – the cutting depth for each
operation should not exceed 5 to
6 cm. Cut thicker material in multiple
operations
N sever large wall thicknesses with
even back and forth movements
Cutting plates
N Secure the plate on a non-slip
surface
N Grind a guide groove (A) along the
line marked
N Make the cut (B) deeper with even
back and forth motions
N Leave a "hinge" (C)
N First sever the plate at the cut ends
so that no material breaks away
N Break plate
N Make curves in multiple operations
– make certain that the cutting
wheel does not tilt
Cutting round and hollow bodies
N Secure pipes, round bodies, etc.
against rolling away
N when determining the cutting line,
avoid reinforcement, especially in
the direction of the severing cut
N Grind a guide groove along the line
marked
N Make cuts deeper with even back
and forth motions – feed with full
cutting depth along the guide
groove – for small corrections of
direction, do not tilt the cutting
wheel, but always position it anew
instead – if necessary, leave small
ridges that hold the part that is to be
separated in position. Break these
ridges later
To Next Page
Loading...
