TS 410, TS 420
English
15
Troubleshooting
Cutting wheel
Error Cause Remedy
ragged edges or cut surfaces, crooked
cut
Deviation in radial or axial run-out Contact a servicing dealer
1)
heavy wear on the sides of the segments Cutting wheel gyrates use a new cutting wheel
ragged edges, crooked cut, no cutting
performance, generation of sparks
Cutting wheel is dull; built-up edges with cut-
ting wheels for stone
Sharpen cutting wheels for stone by
briefly cutting through abrasive materials;
replace cutting wheel for asphalt with a
new one
poor cutting performance, high segment
wear
Cutting wheel is turning in the wrong
direction
Mount cutting wheel so that it turns in the
right direction
Breakdowns or tears in the parent wheel
and segment
Overloading use a new cutting wheel
Undercut Cutting in the wrong material use new cutting wheel; observe separat-
ing layers of various materials
1)
STIHL recommends STIHL servicing dealers
To Next Page
Loading...
