TS 410, TS 420
English
22
The engine must be switched off for
fitting or replacement – set slide control
to STOP or 0.
Blocking the shaft
N Slide the locking pin (1) through the
bore in the V-belt guard
N Turn the shaft with the combination
wrench until the locking pin (1)
engages in the bore behind the
guard
Removing a cutting wheel
N Use the combination wrench to
loosen and remove the hexagon
head screw (2)
N Remove the front thrust washer (3)
from the shaft together with the
cutting wheel
Fitting a new cutting wheel
N Fit the new cutting wheel (4)
N Fit the front thrust washer (3). The
catches of the front thrust
washer (3) must engage in the shaft
grooves.
N Screw in the hexagon bolt and
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
N Draw the locking pin out of the
V-belt guard
Fitting / replacing an
abrasive wheel
370BA014 KN
1
2
370BA053 KN
Note the arrows indicating the
direction of rotation on diamond
cutting wheels.
Never use two cutting wheels at
the same time. The uneven wear
creates a risk of breaking and
an injury hazard!
370BA054 KN
4
To Next Page
Loading...
