Stihl 9 - Adjusting Carburetor; Motor Management; Engine Stops While Idling; Chain Runs When Engine Is Idling

•
Check the air filter and clean it if
necessary.
•
Warm up the engine.
•
Turn screws only very slightly and
carefully - even minor changes
have a noticeable effect on the
engine’s running behavior.
It is usually necessary to change the
setting of the idle speed adjusting screw
/$ after every correction to the low
speed screw /.
(QJLQHVWRSVZKLOHLGOLQJ
•
Turn the idle speed adjusting screw
/$ clockwise
until chain begins to run -
then back off the screw one quarter
of a turn.
&KDLQUXQVZKHQHQJLQHLVLGOLQJ
•
Turn the idle speed adjusting screw
/$ counterclockwise until chain
stops running -
then turn screw another quarter
turn in the same direction.
(UUDWLFLGOLQJEHKDYLRXU
SRRUDFFHOHUDWLRQ
Idle setting is too lean.
•
Turn the low speed adjusting screw
/ counterclockwise until engine
runs and accelerates smoothly.
$GMXVWLQJ&DUEXUHWRU
0RWRU0DQDJHPHQW
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components
(e.g. carburetion, ignition, timing and
valve or port timing) without the addition
of any major hardware.
