Stihl Brushcutter - Mounting the Cutting Tools; Blocking the output shaft; Removing cutting tool mounting hardware

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
/D\\RXUEUXVKFXWWHURQLWVEDFNZLWK
WKHJHDUKHDGIDFLQJXS
%ORFNLQJWKHRXWSXWVKDIW
•
Insert stop pin  in the bore  at
the side of the gear head as far as
stop - apply slight pressure.
•
Rotate output shaft until the stop
pin slips into position and blocks the
shaft.
5HPRYLQJFXWWLQJWRRO
PRXQWLQJKDUGZDUH
•
Position combination wrench 
on the mounting nut .
•
Release and unscrew the nut
clockwise (left-hand thread).
•
Remove shipping keeper  -
if fitted.
•
Pull the rider plate  and
thrust washer  off
the shaft .
•
Now fit the cutting tool.
2
1
0RXQWLQJWKH&XWWLQJ7RROV
4
3
3
57BA014 KN
