Stihl Brushcutter - STIHL Autocut 20-2; Assembling STIHL Autocut 20-2; STIHL Autocut 25-2; Mounting the mowing head

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
5HPRYLQJPRZLQJKHDG
•
Block the output shaft -
unscrew mowing head clockwise.
5HSODFLQJFXWWLQJEODGHV
•
Refer to instruction sheet supplied
with mowing head.
67,+/$XWRFXW
67,+/$XWRFXW
$VVHPEOLQJ67,+/$XWRFXW
•
Push the bolt  into
the mowing head  and
engage it in the hexagon recess.
•
Screw the cap  counterclockwise
on to the bolt and tighten it down
securely.
.HHSLQVWUXFWLRQVKHHWIRUPRZLQJ
KHDGLQDVDIHSODFH
0RXQWLQJWKHPRZLQJKHDG
•
Lay your brushcutter on its back
with the gear head facing up.
•
Screw mowing head counterclock-
wise onto the output shaft  -
as far as it will go.
•
Block the output shaft.
•
Tighten down the mowing head
securely.
,PSRUWDQW
Remove the stop pin.
5HPRYLQJPRZLQJKHDG
•
Block the output shaft -
unscrew mowing head clockwise.
343ET026
343BA025
