Stihl Brushcutter - STIHL Polymatic 30-2; Adjusting nylon line; STIHL Autocut 24-2

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
$GMXVWLQJQ\ORQOLQH
•
Hold the rotating mowing head
horizontal above the ground -
tap it on the ground -
DERXWFP fresh line is
advanced - blade on deflector trims
surplus line to the correct length -
avoid tapping head more than
once.
•
Line feed operates only if
both lines still have a
PLQLPXPOHQJWKRIFP.
•
Fit new nylon line as described in in-
structions supplied with mowing
head.
67,+/3RO\PDWLF
67,+/$XWRFXW
•
Lay your brushcutter on its back
with the gear head facing up.
•
Slip the plain washer  and
thrust washer  over the
shaft  and against the
thrust plate .
•
Screw mowing head counterclock-
wise onto the output shaft -
as far as it will go.
•
Block the output shaft.
•
Tighten down the mowing head
securely.
,PSRUWDQW
Remove the stop pin.
.HHSLQVWUXFWLRQVKHHWIRUPRZLQJ
KHDGLQDVDIHSODFH
5HPRYLQJPRZLQJKHDG
•
Block the output shaft -
unscrew mowing head clockwise.
$GMXVWLQJQ\ORQOLQH
•
Refer to instruction sheet supplied
with mowing head.
357BA017 KN
