Stihl Brushcutter - STIHL Fixed Line Head; Releasing mounting nut; Fitting nylon line

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
67,+/)L[HG/LQH+HDG
•
Lay your brushcutter on its back
with the gear head facing up.
•
Position the head on the thrust
plate  .
•
Slip the thrust washer  over the
output shaft .
•
Block the output shaft.
•
Screw mounting nut  counter-
clockwise on to the output shaft and
tighten it down firmly.
,PSRUWDQW
Remove the stop pin.
.HHSLQVWUXFWLRQVKHHWIRUPRZLQJ
KHDGLQDVDIHSODFH
5HOHDVLQJPRXQWLQJQXW
•
Block the output shaft and
unscrew the mounting nut
clockwise.
If the mounting nut becomes slack due
to frequent loosening and retightening,
fit a new one.
)LWWLQJQ\ORQOLQH
•
Refer to instruction sheet supplied
with fixed line head.
357BA019 KN
