Stihl Brushcutter - Spark Arresting Screen in Muffler; Gearbox Lubrication

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
•
Install foam filter element .
•
Fit the filter cover with the
choke lever  in the closed
position - line up choke mark
on filter cover with . of &+2.(
on housing.
•
Secure cover with screw .
If the engine is low on power, check the
spark arresting screen inside the muffler.
•
Slacken off but do not remove the
screws 
•
Pull out the spark arresting screen
 from underneath the cover 
in the direction of the arrow (see
illustration).
•
Clean spark arresting screen if
necessary.
•
If screen is damaged or coked up,
fit a new one.
•
Refit the spark arresting screen.
•
Assemble in the reverse sequence.
*Not all models
•
Check grease level regularly
- about every 50 hours of
operation.
•
Unscrew the filler plug .
•
If no grease can be seen on the insi-
de of the filler plug, screw the tube
 of STIHL gear lubricant
0781 120 1117/1119 into the filler
hole.
•
Squeeze grease into the gear
housing - about 5 - 10 g (1/4 oz).
•
Do not completely fill the
gear housing with grease.
•
Refit the filler plug and tighten it
down firmly.
6SDUN$UUHVWLQJ6FUHHQLQ
0XIIOHU
*HDUER[/XEULFDWLRQ
3
43BA052
357BA050 KN
343BA051
