Stihl FCB - Recommended Power Tool Combinations

12
english / USA
FCB
Edging
: Start the engine.
: Start the cut at no less than half
throttle and continue cutting at full
throttle.
: Hold and guide your edger so that
the blade is vertical.
: Cut steadily so that the engine is not
lugged down – do not apply force.
: Cut at a normal walking pace.
: Do not push the blade into the
ground.
: Always walk forwards when cutting,
do not pull the unit towards you.
: Edge at a steady pace to avoid
having to make several passes.
1 = Gunning sight for edger blade
The STIHL power edger attachment is
available only as an interchangeable
attachment for mounting to approved
power tools with a split boom.
The following power tools are approved:
STIHL FR 85 T, FS 55 T
1)
, FS 85 T
1)
and FS 100 T
1)
, FS 110 T
1)
.
Other combinations of the edger
attachment and non-approved
power tools are not permitted since
they may result in accidents or
serious personal injury.
It is not necessary to mount a barrier
bar* to the loop handle.
1)
Attachment not approved for units
with a bike handle.
* see "Guide to Using this Manual"
241BA004 KN
90°
241BA005 KN
1
Recommended Power Tool
Combinations