Stihl FR 235 - Mounting Loop Handle with Barrier Bar; Mounting and Removing the Deflector; Mounting and Removing the Mowing Head

6.5 Mounting Loop Handle with
Barrier Bar
► Shut off the engine.
a
2
1
6
4
5
7
8
3
0000-GXX-7842-A0
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (4) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert the screws (8).
► Slide the loop handle (3) on the drive tube until
distance ‘b’ is no more than 20 cm.
► Tighten down the screws (8) firmly.
6.6 Mounting and Removing the
Deflector
6.6.1 Mounting the guard
► Shut off the engine.
1
2
0000-GXX-3027-A0
► Push the deflector (1) into the guides on the
gear housing up to the limit stop.
► Insert the screws (2) and tighten them firmly.
6.6.2 Removing the Deflector
► Shut off the engine.
► Take out screws.
► Remove guard.
6.7 Fitting and Removing the Skirt
6.7.1 Fitting the Skirt
► Shut off the engine.
3
2
4
0000-GXX-3028-A1
1
► Slide the guide slot in the skirt (2) onto the
deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.7.2 Removing the Skirt
► Shut off the engine.
1
0000-GXX-3030-A2
2
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the
deflector.
The line limiting blade (1) can be left on the skirt.
6.8 Mounting and Removing the
Mowing Head
6.8.1 Mounting the Mowing Head
► Shut off the engine.
2
3
4
0000-GXX-3031-A0
1
4
1
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise.
► Insert the stop pin (4) in the bore as far as
stop and hold it depressed.
English 6 Assembling the Trimmer
12 0458-527-0121-B