FS 260 C, FS 360 C
English
27
FS 360 C
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Machine".
The type and version of the harness and
snap hook depend on the market.
FS 260 C
Connect machine to harness
N Hook the snap hook (1) into the
carrying ring (2) on the drive tube
Hanging positions
Mowing heads, grass cutting blades and
brush knives should rest lightly on the
ground.
Circular saw blades should "hover"
approx. 8 in. (20 cm) above the ground.
Carry out the following steps to attain the
proper hanging position:
Letting the machine swing until it
stops moving
N Undo the screw (3)
N Adjust carrying ring (2) – tighten
screw lightly – let the machine swing
until it stops moving – check
hanging position
Once the proper hanging position has
been attained:
N Tighten the screw on the carrying
ring
3
002BA411 KN
1
2
Balancing the
Trimmer/Brushcutter
1
2
1
2
002BA387 KN
002BA388 KN
002BA389 KN
3
2
002BA390 KN