Need help?Do you have a question about the Stihl FS 50 C and is the answer not in the manual?
General| Engine Displacement | 27.2 cc |
|---|---|
| Power Output | 0.8 kW |
| Engine Type | 2-stroke |
| Shaft Type | Straight |
| Sound Pressure Level | 94 dB(A) |
| Fuel Tank Capacity | 330 ml |
| Vibration Levels | 4.5 m/s² (left) / 4.5 m/s² (right) |
Emphasizes reading manual and observing safety precautions to avoid injury or death.
Check cutting attachment for condition, tightness, and cracks; replace if damaged.
Keep others 15m away; watch for obstacles; maintain balance and footing.
Check cutting attachments for wear and damage; replace immediately if cracked.
Check spark plug, ignition lead, and muffler condition; do not touch hot muffler.
Start engine outdoors, 3m from fuel, with secure footing and clear attachment.
Operate in well-ventilated areas; stop if experiencing health symptoms.
Do not smoke; avoid hot exhaust near combustible materials.
Advises using only cutting attachments and accessories explicitly approved by STIHL.
Stresses wearing face shield and safety glasses to protect against thrown objects.
Recommends wearing hearing protection like earplugs or ear muffs.
Warns gasoline is flammable; keep clear of flames and do not smoke.
Emphasizes shutting off engine before refueling.
Advises not to fuel a hot engine to prevent fires.
Advises checking for fuel leakage and not running engine if leaks are found.
Service regularly; use authorized STIHL dealers for repairs and genuine parts.
Service machine regularly; only perform work described in manual.
Users perform manual tasks; dealers handle all other repairs.
Shut off engine and disconnect spark plug boot before maintenance.
Use high-quality replacement parts; STIHL recommends authorized dealers.
Check mowing heads for wear limits; replace if worn to avoid shattering risk.
Check PolyCut blades for cracks; avoid stones/metal; replace all blades if one is cracked.
Check wear limit marks on PolyCut; replace if worn to avoid shattering risk.
Select correct combinations from table for safety; only use approved attachments, deflectors, handles, and harnesses.
Shut off engine before adjusting nylon line by hand.
Engine requires unleaded gasoline and 50:1 mix; use premium fuel and two-stroke oil.
Instructions for pulling starter grip; includes ErgoStart details and safety.
Press fuel pump bulb; use choke lever for cold/warm starts; ensure firm footing.
Press interlock, open throttle; ensure cutting tool does not rotate at idle.
Move stop switch to '0' to stop the engine.
Describes steps for cleaning air filter if engine power is low.
Adjust idle speed screw (LA) to stop cutting attachment rotation; also addresses lean/rich idle.
Check spark plug if engine power is low or starts poorly; inspect for fouling.
Clean spark plug, check electrode gap, use correct plug type; address fouling causes.
Ensure spark plug boot is snugly connected to prevent arcing and fire.
Check spark arresting screen in muffler if engine power is down.
STIHL recommends authorized STIHL servicing dealers for servicing and repair work.
To Next Page
