Stihl FS 260 C User Manual

FS 260 C, FS 360 C
English
35
N Fit the cap (1) on the shroud from
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
N Swing the cap forwards onto the
shroud, insert and tighten down the
screw (4) firmly.
If engine running behavior is
unsatisfactory even though the air filter
is clean and the carburetor and throttle
cable are properly adjusted, the cause
may be the muffler.
Have the muffler checked by a servicing
dealer for contamination
(carbonization).
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
Removing the rewind starter
N Take out the screws (1).
N Lift away the rewind starter.
Removing the rope rotor
N Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
N Carefully remove the E-clip (3).
4
3
2
9926BA022 KN
Engine Running Behavior Replacing the Starter Rope
and Rewind Spring
1 1
1 1
9926BA023 KN
3
2
9926BA024 KN

Stihl FS 260 C Specifications

General

Fuel Capacity	0.75 L
Engine Type	2-stroke
Shaft Type	Straight
Vibration Damping	Yes
Power Output	2.0 kW
Cutting Diameter	420 mm
Starter System	Recoil